Shop drawings · CSI Division 09
Flooring layouts with every seam and transition.
Flooring shop drawings for flooring contractors, with sheet goods and carpet seamed, tile patterns and install directions set, and every transition and base type located.
- Finish plans
- Seam layouts
- Pattern and direction plans
What you receive
A drawing set ready for your submittal.
Drafted in AutoCAD and Revit, with anything the contract drawings leave open listed for your RFIs.
- 01
PDF set for submittal
- 02
Native DWG or RVT files
- 03
Imperial or metric units
Drawing set
What the set includes.
The sheets in a typical set of flooring shop drawings. The exact list follows your contract drawings and specification section.
Sheet
What it shows
- Finish plansEvery floor finish code by room, with boundaries at doorways and transitions.
- Seam layoutsSheet vinyl, sheet rubber and broadloom seams, roll direction and cuts.
- Pattern and direction plansCarpet tile install method, resilient tile patterns and plank direction.
- Transition detailsTransition strip types where finishes meet, by finish pair.
- Base plansBase type and height, wall by wall.
- Static-dissipative floorsGrounding strip locations and conductive layers, where the scope includes them.
Method
How we prepare flooring shop drawings.
Seams are kept out of traffic paths and doorways where the material allows.
Finish boundaries are set at door centerlines, or where the drawings show them.
Transitions are listed by the two finishes they join.
Where the finish plan and the schedule disagree, it is listed as a question.
Standards
The references your reviewer expects.
We draft to the standards your contract drawings and specification cite. These are the ones we see most often for this trade.
The manufacturer's installation guidelines
Seaming, layout and acclimation for the specified products.
CRI 104 and ASTM F710
Commercial carpet installation, and floor preparation for resilient flooring.
Deliverables
What every set includes.
- PDF drawing set, ready for your submittal
- Native files: DWG from AutoCAD or RVT from Revit
- A list of open questions and conflicts, for you to raise as RFIs
- Revisions to the reviewer's comments, recorded in the title block
- Imperial or metric units, to match the contract drawings
- Drafted in AutoCAD and Revit
Who it is for
- Flooring contractors
- Carpet and resilient installers
- Interior contractors
- General contractors
Related
Shop drawings for the trades next to yours.
Questions contractors ask us
Do you draw seam layouts?
Can you set the carpet tile install direction?
Do you estimate flooring too?
Are the shop drawings stamped?
How are shop drawings priced?
Flooring shop drawings
Submittal due soon? Send the contract set.
Send the contract drawings, the specification section and the submittal date, and we will quote the flooring shop drawings.
