Shop drawings · CSI Division 09

Tile shop drawings, from pattern to movement joint.

Tile layout drawings for tile contractors, with floor and wall patterns set out from a starting point, cuts balanced, and movement joints, transitions, trims and membranes shown.

  • Floor tile layouts
  • Wall tile elevations
  • Movement joint plans

What you receive

A drawing set ready for your submittal.

Drafted in AutoCAD, Revit and 3ds Max, with anything the contract drawings leave open listed for your RFIs.

  • 01

    PDF set for submittal

  • 02

    Native DWG or RVT files

  • 03

    Imperial or metric units

Drawing set

What the set includes.

The sheets in a typical set of tile shop drawings. The exact list follows your contract drawings and specification section.

  • Floor tile layoutsPattern, starting point, joint width and cut tiles for each room.
  • Wall tile elevationsCoursing, heights, accent bands and cuts at fixtures and openings.
  • Movement joint plansPerimeter and field movement joints, at the spacing the specification sets.
  • Trim and transition detailsMetal edge trims, cove strips and transitions to other floor finishes.
  • Wet-area detailsMembranes, slopes to drains, curbs and shower pans.
  • Tile scheduleTile codes with manufacturer, size, pattern, grout and setting method.

Method

How we prepare tile shop drawings.

01

Layouts start from a set point, so cuts are balanced at walls and doorways.

02

Floor and wall joints are aligned where the drawings ask for it.

03

Floor drains and slopes are coordinated with the plumbing drawings.

04

Setting methods and membranes follow the method numbers the specification cites.

Standards

The references your reviewer expects.

We draft to the standards your contract drawings and specification cite. These are the ones we see most often for this trade.

TCNA Handbook

Installation methods, including EJ171 for movement joints.

ANSI A108, A118 and A136

Tile installation and setting material standards on US projects.

TTMAC Specification Guide 09 30 00

The tile installation manual cited on Canadian projects.

Deliverables

What every set includes.

  • PDF drawing set, ready for your submittal
  • Native files: DWG from AutoCAD or RVT from Revit
  • A list of open questions and conflicts, for you to raise as RFIs
  • Revisions to the reviewer's comments, recorded in the title block
  • Imperial or metric units, to match the contract drawings
  • Drafted in AutoCAD, Revit and 3ds Max

Who it is for

  • Tile contractors
  • Flooring contractors
  • Interior contractors
  • General contractors

Questions contractors ask us

Do you show movement joints?

Yes. Perimeter and field movement joints are located on the layouts, at the spacing the specification or TCNA EJ171 requires.

Can you set out a pattern from a fixed point?

Yes. Tell us where the pattern must start, such as a doorway or the center of a room, and the layout balances the cuts from there.

Do you estimate tile too?

Yes. Our tile estimating measures floor and wall tile, grout, membranes and trims by tile code.

Are the shop drawings stamped?

Shop drawings are submittals: the architect or engineer of record reviews and approves them. If your project needs a professional engineer's stamp, for example on delegated design, tell us at the quote stage and we will confirm what can be arranged for that project.

How are shop drawings priced?

We review the contract drawings and the specification section, then confirm the fee and the delivery date before any drafting starts.

Tile shop drawings

Submittal due soon? Send the contract set.

Send the contract drawings, the specification section and the submittal date, and we will quote the tile shop drawings.