Shop drawings · CSI Division 07

Waterproofing shop drawings, edge to edge.

Waterproofing shop drawings for waterproofing contractors, showing where each system goes and how it is terminated, lapped and sealed at drains, penetrations and transitions.

  • System layout plans
  • Termination details
  • Penetration and drain details

What you receive

A drawing set ready for your submittal.

Drafted in AutoCAD and Revit, with anything the contract drawings leave open listed for your RFIs.

  • 01

    PDF set for submittal

  • 02

    Native DWG or RVT files

  • 03

    Imperial or metric units

Drawing set

What the set includes.

The sheets in a typical set of waterproofing shop drawings. The exact list follows your contract drawings and specification section.

  • System layout plansBelow-grade walls, decks, balconies, plazas and wet areas, each with its system.
  • Termination detailsTop-of-wall, deck edge, threshold and parapet terminations.
  • Penetration and drain detailsPipe penetrations, drains and sleeves.
  • Transition detailsWhere below-grade waterproofing meets the air barrier or the roof.
  • Protection and drainage layersDrainage composite, protection board and overburden.

Method

How we prepare waterproofing shop drawings.

01

Each area keeps the system the specification assigns to it, so a deck coating and a below-grade membrane are never confused.

02

Details start from the manufacturer's standard details for the specified products.

03

Transitions between systems and trades are drawn, not left as a note.

04

Conflicting details are listed as questions before the drawings are issued.

Standards

The references your reviewer expects.

We draft to the standards your contract drawings and specification cite. These are the ones we see most often for this trade.

The manufacturer's standard details

The specified product's details, adapted to the conditions on your drawings.

Your specification section

System selection, laps, terminations and testing requirements.

Deliverables

What every set includes.

  • PDF drawing set, ready for your submittal
  • Native files: DWG from AutoCAD or RVT from Revit
  • A list of open questions and conflicts, for you to raise as RFIs
  • Revisions to the reviewer's comments, recorded in the title block
  • Imperial or metric units, to match the contract drawings
  • Drafted in AutoCAD and Revit

Who it is for

  • Waterproofing contractors
  • Coating and sealant contractors
  • Building envelope contractors
  • General contractors

Questions contractors ask us

Do you use the manufacturer's details?

Yes. Details start from the manufacturer's standard details for the specified products and are adapted to the conditions on your drawings.

Can you show where each system goes?

Yes. Layout plans assign a system to every area, from below-grade walls and decks to balconies and wet areas.

Do you estimate waterproofing too?

Yes. Our waterproofing estimating measures each system by area where it is applied, and sealants by length.

Are the shop drawings stamped?

Shop drawings are submittals: the architect or engineer of record reviews and approves them. If your project needs a professional engineer's stamp, for example on delegated design, tell us at the quote stage and we will confirm what can be arranged for that project.

How are shop drawings priced?

We review the contract drawings and the specification section, then confirm the fee and the delivery date before any drafting starts.

Waterproofing shop drawings

Submittal due soon? Send the contract set.

Send the contract drawings, the specification section and the submittal date, and we will quote the waterproofing shop drawings.