Shop drawings · CSI Division 04
CMU wall shop drawings, course by course.
Masonry shop drawings for CMU and veneer contractors, with each wall drawn in elevation showing reinforcing, bond beams, lintels, control joints, openings and grouted cells.
- Wall elevations
- Reinforcing layouts
- Lintel schedule
What you receive
A drawing set ready for your submittal.
Drafted in AutoCAD and Revit, with anything the contract drawings leave open listed for your RFIs.
- 01
PDF set for submittal
- 02
Native DWG or RVT files
- 03
Imperial or metric units
Drawing set
What the set includes.
The sheets in a typical set of CMU shop drawings. The exact list follows your contract drawings and specification section.
Sheet
What it shows
- Wall elevationsEvery CMU wall in elevation, with coursing, openings, bond beams and control joints.
- Reinforcing layoutsVertical bars, joint reinforcement and bond beam bars, with laps and dowels.
- Lintel scheduleLintel type, length, bearing and reinforcing at each opening.
- Grout plansGrouted cells and solid-grouted areas, wall by wall.
- Control joint layoutsJoint locations and details on every elevation.
- Veneer layoutsBrick and stone veneer coursing, ties, flashing and weeps, where the scope includes veneer.
Method
How we prepare CMU shop drawings.
Coursing is laid out from the floor and opening elevations, so cuts are visible before the wall is built.
Reinforcing comes from the structural drawings and is shown cell by cell where it changes.
Embeds, anchor bolts and MEP penetrations through the wall are located on the elevations.
Where the structural and architectural drawings disagree on wall height or opening size, it is listed as a question for the engineer.
Standards
The references your reviewer expects.
We draft to the standards your contract drawings and specification cite. These are the ones we see most often for this trade.
TMS 402/602
Building code requirements and specification for masonry structures on US projects.
CSA S304 and CSA A371
Masonry design and masonry construction for buildings in Canada.
Deliverables
What every set includes.
- PDF drawing set, ready for your submittal
- Native files: DWG from AutoCAD or RVT from Revit
- A list of open questions and conflicts, for you to raise as RFIs
- Revisions to the reviewer's comments, recorded in the title block
- Imperial or metric units, to match the contract drawings
- Drafted in AutoCAD and Revit
Who it is for
- Masonry contractors
- CMU and retaining wall contractors
- General contractors
- Rebar fabricators supplying masonry steel
Related
Shop drawings for the trades next to yours.
Questions contractors ask us
Do you show which cells are grouted?
Can you include brick or stone veneer?
Do you estimate masonry too?
Are the shop drawings stamped?
How are shop drawings priced?
CMU & Masonry shop drawings
Submittal due soon? Send the contract set.
Send the contract drawings, the specification section and the submittal date, and we will quote the CMU shop drawings.
