Shop drawings · CSI Division 22

Plumbing shop drawings, sized, sloped and coordinated.

Plumbing shop drawings for plumbing contractors, with sanitary, vent, storm and domestic water piping routed, sized and sloped, and sleeves, hangers and fixture rough-ins located.

  • Underground plans
  • Above-ground piping plans
  • Sleeve and penetration plans

What you receive

A drawing set ready for your submittal.

Drafted in AutoCAD and Revit, with anything the contract drawings leave open listed for your RFIs.

  • 01

    PDF set for submittal

  • 02

    Native DWG or RVT files

  • 03

    Imperial or metric units

Drawing set

What the set includes.

The sheets in a typical set of plumbing shop drawings. The exact list follows your contract drawings and specification section.

  • Underground plansBelow-slab sanitary and storm piping, with inverts and slopes.
  • Above-ground piping plansSanitary, vent, storm and domestic water routing, with sizes and elevations.
  • Sleeve and penetration plansSleeves through slabs and walls, for the concrete and framing trades.
  • Riser diagramsRisers by system, with sizes and floor-to-floor connections.
  • Fixture rough-in elevationsRough-in heights and locations for fixtures and equipment.
  • Hanger layoutsHanger and support locations.

Method

How we prepare plumbing shop drawings.

01

Pipe sizes and slopes come from the plumbing drawings, and inverts are worked out along each run.

02

Routing is coordinated with structure, duct and other trades, and clashes are listed as questions.

03

Sleeves are located for each slab pour.

04

Fixture rough-ins are taken from the fixture schedule and the manufacturer data.

Standards

The references your reviewer expects.

We draft to the standards your contract drawings and specification cite. These are the ones we see most often for this trade.

IPC or UPC, as adopted

The plumbing code the contract drawings reference on US projects.

National Plumbing Code of Canada and the provincial codes

The Canadian equivalents, referenced on Canadian drawing sets.

Deliverables

What every set includes.

  • PDF drawing set, ready for your submittal
  • Native files: DWG from AutoCAD or RVT from Revit
  • A list of open questions and conflicts, for you to raise as RFIs
  • Revisions to the reviewer's comments, recorded in the title block
  • Imperial or metric units, to match the contract drawings
  • Drafted in AutoCAD and Revit

Who it is for

  • Plumbing contractors
  • Mechanical contractors
  • Design-build MEP firms
  • General contractors

Questions contractors ask us

Do you show inverts and slopes?

Yes. Underground and above-ground drainage is drawn with slopes and inverts along each run.

Can you issue sleeve drawings before the pour?

Yes. Sleeve and penetration plans can be issued ahead of the full set, so the concrete contractor can place them.

Do you estimate plumbing too?

Yes. Our plumbing estimating measures fixtures and piping from the same drawings.

Are the shop drawings stamped?

Shop drawings are submittals: the architect or engineer of record reviews and approves them. If your project needs a professional engineer's stamp, for example on delegated design, tell us at the quote stage and we will confirm what can be arranged for that project.

How are shop drawings priced?

We review the contract drawings and the specification section, then confirm the fee and the delivery date before any drafting starts.

Plumbing shop drawings

Submittal due soon? Send the contract set.

Send the contract drawings, the specification section and the submittal date, and we will quote the plumbing shop drawings.